Threading a Sani Professional® Canister

Not sure how to thread one of our Sani Professional canisters? This video can help! Scroll down for the Spanish-language version.

Video Transcript for Threading a Canister (English):

Threading a Sani Professional canister.

Begin by removing the canister lid. Next, locate the tab on the white plastic film and pull upward to remove film entirely and dispose.

Then locate the starter wipe from the middle of the roll and pull it up 3-4 inches by the corner. Flip open the very top of the lid to reveal the dispensing hole. Twist the upper corner of the exposed wipe. Thread that corner of the wipe through the lid dispensing hole.

Secure the lid back onto the canister and pull the first wipe upward and at an angle until it tears at the perforation.

Tuck the next exposed wipe into the lid well and close the tab to ensure the wipes remain moist.

Para enhebrar un contenedor Sani Professional® (Español)

Transcripción Español

Para enhebrar un contenedor Sani Professional, siga los siguientes pasos:

Primero, quite la tapa del recipiente.

Luego, retire completament el plastico blanco usando la lengueta; deséchelos.Luego, localice la lengüeta en el plastico blanco y retire completemete el plastico blanco y deséchelos. Ahora, localice la primera toallita en el centro del rollo y hale por la esquina, unas 3 o 4 pulgadas. Abra la parte superior de la tapa para ver el lugar de dispensación. Retuerza la esquina superior de la toallita expuesta. Pásela por el agujero de dispensación, en dirección de abajo hacia arriba.

Tape el recipiente dejando abierta la tapa superior. Hale la primera toallita hacia adelante y en ángulo hasta que se rompa en la perforación. Cierre la tapa superior.

Asegúrese de mantener la tapa muy bien cerrada para que el resto de las toallitas se permanezca húmedo.